100 lbs Concrete Filled Umbrella Base SC40

Product Info

Concrete Filled SC60 Base

Features

• Commercial grade base providing cost efficient solution.
• Engineered for high wind areas.
• Galvanized plate, metallized tube and powder coated for superior rust protection.
• Metal reinforcements inside amongst the concrete for extra reinforcement.
• Interchangeable choice of tubes for a large range of pole diameters with the use of reducer rings and two tightening knobs.

Specifications

Concrete Filled Base Dimensions
SC40
100 lbs Weight
1.5″ – 1.8″ Umbrella Poles (T12 Tube – Standard)
1.8″ – 2.25″ Umbrella Poles (T13 Tube)
20″ Square Plate (a)
2.4″ Plate Height (b)
18.8″ Height (c)

Installation Info

Low Profile and Concrete Filled Bases Install

Easy Assembly

These bases come in two boxes. Once carefully unboxed, place the plate in desired level location. Set the tube ontop of the plate, lining up the four holes. Take the hardware that was included in the tube’s box. One at a time, take one washer and one bolt to one of the four holes you lined up, washer between the hole and the screw. Use the included hex wrench to secure and tighten the screws. Repeat until all four screws are fastened.

To prepare for your umbrella, un-tighten the two black triangular grip fastening knobs and take out any black reducer rings in the top of the tube that is smaller then your umbrella pole.

Note that these bases are heavier than your average base, so unboxing and moving the plate around may take two people.